IMPORTANT NOTE:

  • Charge your battery fully before updating your Notifier watches firmware.
  • If your Watch is not updated within 5 minutes, unplug the Watch from the computer and restart the Firmware Update process. Do not allow your Watch battery to drain completely before finishing the Firmware Update.
  • Do not use the “Update Mode” on the Watch unless instructed to do so by a Martian Customer Service representative.

1. Click the “Download” link below that corresponds to your Windows operating system.

2. Double-Click on the downloaded file

3. Follow the instructions within the Martain Notifier Firmware Updater program. You will be prompted to connect your watch at the appropriate time.

4. Once the Martian Notifier Firmware Updater is installed on your Computer, click “Finish” and the Martian Notifier Firmware Updater will begin the Firmware Update process.

5. When prompted, connect the Martain Notifier Watch to your computer using your Martian micro USB cable (other cables may not work). Then click “Next”.

6. The Firmware Updater will update the firmware of your Martian Notifier watch. The update will take up to 5 minutes but should be much quicker. You will see progress bars on your computer. If you don’t see progress after 5 minutes (progress bar is frozen) or if you receive an error message, stop the update, close the Firmware Updater, and unplug/re-plug the watch to reset it and start again. If the update process is successful, you will see an “Upgrade Successful” page. Disconnect your watch and enjoy your new features!


If the installation fails, click “Finish”, return to C:/Program Files/Martian Notifier Firmware Updater/ (as long as you did not change the install destination), and double-click DFUWizard.exe. Unplug and re-plug your cable into your Computer and try again.


Note for Windows 8 Users: When downloading the Firmware installer for Windows 8 you may get a security warning about the file being downloaded. Let us assure you that our Firmware installer is free of viruses and is perfectly safe to install on your computer. Please click the arrow to the right of the Discard button and select Keep. Further, when you double-click on the downloaded file on Window 8, you may receive a message that “Windows protected your PC”. Please click the More Info link and click Run Anyway to proceed with the installation of Firmware for your Martian Notifier watch. These errors will not appear on Windows 7. This is new to Windows 8 security for downloaded Internet files.


If the firmware installer does not support Window 10 operating system, please click here for the workaround.